Electric Actuators
IQT - Part Turn Actuator
DESIGN FEATURES:
With the revolutionary dual stacked display, information about your plant and process is available at your fingertips allowing unparalleled data analysis of the condition and operational status of the valve; data analysis that enables accurate asset management of your plant. Rotork innovation at its best.
Variants:
IQT Standard, IQT Failsafe, IQT Modulating, IQT Full Turn
IQ3 Range Multi-Turn Actuator
DESIGN FEATURES:
For over 50 years Rotork have used innovation for designing reliable, flexible and robust valve actuators and control systems. Continuing our ethos of evolving design, the next generation IQ multi-turn actuators are now available. Reliability standards have been set even higher, it is simpler to commission and use and is unrivaled in its ability to provide valve and process control operational data.
Variants:
IQ Standard, IQM Modulating, IQS Single Phase, IQD Direct Current
A Range Actuator
DESIGN FEATURES:
The 'A' range combines the qualities of a robust electric motor and a well proven simple mechanical drive. Total environmental sealing to IP68 allows the inclusion of integral motor starter and control electronics. Torque range 14 to 3,000 Nm (10 to 2,200 lbf-ft) direct drive, up to 250,000 Nm (185,000 lbf-ft) quarter-turn and up to 40,800 Nm (30,000 lbf-ft) multi-turn (rotary).
AWT Range Actuator
DESIGN FEATURES:
The AWT range combines the qualities of a robust electric motor and a well proven simple mechanical drive. Total environmental sealing to IP68 allows the inclusion of integral motor starter and control electronics. Torque range 14 to 3,000 Nm (10 to 2,200 lbf-ft) direct drive, up to 250,000 Nm (185,000 lbf-ft) quarter-turn and up to 40,800 Nm (30,000 lbf-ft) multi-turn (rotary).
Q Range Actuator
DESIGN FEATURES:
The Q range is a single-phase quarter-turn direct drive electric actuator available in two versions, both environmentally sealed to IP68. Q standard for simple open/close duties where on/off control is required and the Q Pak which incorporates a specially designed control interface module enabling operation from a variety of remote control signals. Torque range 30 to 406 Nm (22 to 300 lbf-ft).
ROM Actuator
DESIGN FEATURES:
ROM actuators provide quiet and reliable operation for all kinds of small ball valves and butterfly valves, as well as dampers and ventilation louvres. They provide self-locking as standard, local visual indicators and manual override options together with a wide range of voltages. Torque range 35 to 650 Nm (25 to 480 lbf-ft).
ROMpak Actuator
DESIGN FEATURES:
Building on the simple specification of the ROM / RBM range, Rotork now offer a more complete control solution with the introduction of the new ROMpak. ROMpak introduces: Local controls for ease of operation; Dual local indicators – mechanical and LED; Phase rotation correction for ease of installation; Options including: bus communication and Folomatic/CPT. Torque range 35 to 650 Nm (25 to 480 lbf-ft).